LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Shift Control Cable Replacement - Floor Shift >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the cable to the vehicle through the cowl and the carpet.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the cable grommet in the cowl.
    3. Fig 1: View Of Range Select Lever Cable
    GM104480Courtesy of GENERAL MOTORS CORP.
  3. Install the range select lever cable at the automatic transmission control.
  4. Install the front floor console. Refer to Console Replacement - Front Floor in Body -Instrument Panel and Console.
    5. Fig 2: View Of Range Select Lever Cable
    GM104478Courtesy of GENERAL MOTORS CORP.
  5. Install the range select lever cable to the cable bracket.
    6. Fig 3: Identifying Automatic Transmission Cable & Selector Lever
    GM893831Courtesy of GENERAL MOTORS CORP.
  6. Install the range select lever cable to the selector lever.
  7. Connect the negative battery cable.
  8. Adjust the cable.
    1. Place the shift lever in N (Neutral). Rotate the selector shaft clockwise from P (Park) through R (Reverse) into N (Neutral).
    2. With the shift control assembly in N (Neutral) lift the cable connector locking clip up.
    3. Push the clip on the cable connector until fully seated and flush with cable body.
scientia non olet · About LEMON Manuals