LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Bonneville SLE >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Cable Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

IMPORTANT:
  • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
  • Always route the replacement cable the same way as the original cable.
    Fig 1: Locating Push-In Retainers Securing Upper Filler Panel To Vehicle
    GM130499Courtesy of GENERAL MOTORS CORP.
  1. Remove the push in retainers (2) securing the upper filler panel (1) to the vehicle.
  2. Remove the upper filler panel (1) from the vehicle.
  3. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  4. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 4.6L.
    5. Fig 2: Locating Positive Battery Cable At Underhood Fuse Block
    GM574502Courtesy of GENERAL MOTORS CORP.
  5. Remove the nut (1) securing the battery positive cable to the remote positive terminal.
    6. Fig 3: Locating Starter Motor BAT Terminal Wire At Starter
    GM104910Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the starter motor BAT terminal wire from the starter.
    7. Fig 4: Locating Generator Output BAT Terminal Nut & Positive Lead At Generator
    GM780408Courtesy of GENERAL MOTORS CORP.
  7. Reposition the protective boot from the generator output BAT terminal for access.
  8. Remove the generator output BAT terminal nut and disconnect the positive lead from the generator.
  9. Disconnect the cable harness clips from the front of the camshaft cover.
  10. Remove the generator cable from the vehicle.
scientia non olet · About LEMON Manuals