Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Upper Plenum Heat Shield Retainer

Courtesy of GENERAL MOTORS CORP.

Position the heat shield with the rearward edge between the retention fingers.
Position the shield onto the ground stud.
Install the push-in retainer attaching the heat shield to the wheelhouse panel.

Fig 2: Battery Heat Shield

Courtesy of GENERAL MOTORS CORP.

Install the push-in retainer attaching the air inlet screen and the battery heat shield to the plenum panel.