LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Heat Shield
    GM753689Courtesy of GENERAL MOTORS CORP.
  1. Place the catalytic converter heat shield onto the floor panel studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the heat shield with the 5 bolts.

    Tighten:  Tighten the catalytic converter heat shield bolts to 7 N.m (62 lb in).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals