Purge Flow Sensor: Service and Repair

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. EVAP Tank Pressure Control Solenoid vacuum valve electrical connector.
3. Two vacuum hoses from EVAP Tank Pressure Control Solenoid vacuum valve.
4. One screw and EVAP Tank Pressure Control Solenoid vacuum valve from bulkhead.

INSTALL OR CONNECT
1. EVAP Tank Pressure Control Solenoid vacuum valve to bulkhead; secure with one screw.
2. Two vacuum hoses to EVAP Tank Pressure Control Solenoid vacuum valve.
3. EVAP Tank Pressure Control Solenoid vacuum valve electrical connector.
4. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb ft).