September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Overhaul & Testing - 700-R4/4L60
- Application
- Identification
- Description
- Lubrication & Adjustments
- On-Vehicle Service
- Trouble Shooting
- Notes
- 1ST Gear Only, No Upshift
- Slips In 1ST
- High Or Low 1-2 Shift Speeds
- Slipping Or Rough 1-2 Shift
- Slipping, Rough Or No 2-3 Shift
- Slipping, Rough Or No 3-4 Shift
- No "R" Or Slips In "R"
- No Part Throttle Or Delayed Downshifts
- No Overrun Braking In Manual 3-2-1
- Drives (Creeps) In Neutral
- Starts In 2ND In "D"
- No Park
- Oil Pressure High Or Low
- High Or Low Shift Points
- No Converter Clutch Apply
- Converter Shudder
- No Converter Clutch Release
- Ratcheting Noise
- Oil Leaking Out Vent
- Vibration In Reverse & Whining Noise In Park
- Front Oil Leak
- No Reverse, Slips In Reverse, Bad Engagement (No Braking Or Weak Braking In Manual Low)
- Pump Bushing Spins Out, "Walks" Into Seal, Or Seizes To Converter Hub
- Slip On 2-3 Shift, Falling Out Of 3RD, Repeated 3-4 Clutch Or 2-4 Band Failure
- Delayed Or No Forward Clutch Engagement, Slips Or Chatters In 1ST Gear
- No 4TH Gear, No 3-4 Upshift (Stays In 3RD, 2ND Usually Okay)
- Falls Out Of 4TH Gear During Coasting
- Binds Up On 3-4 Shift (Feels Like Brake Drag)
- No Forward Or Reverse Gears (Line Pressure Reading Okay)
- Binds Up In Reverse
- No Reverse
- No Drive In Drive Range
- No Drive In Overdrive Range
- Clutch & Band Application
- Testing
- Torque Converter
- Removal & Installation
- Transmission Disassembly
- Component Disassembly & Reassembly
- Cleaning & Inspection
- Transmission Reassembly
- Service Bulletins
- No Upshift Or Stuck In 1ST Gear
- No 3RD Or 4TH Gear Or Slipping In 3RD Or 4TH Gear
- No 4TH Gear, Late Or Falls Out Of 4TH Gear
- Loss Of Wide Open Throttle 3-4 Upshift When Hot
- Redesigned Output Shaft & Input Housing-To-Output Shaft Seal
- Redesigned 3-4 Steel Clutch Plates
- New 3-4 Clutch Friction Material
- PEENED Spacer Plate
- Noise In Shift Lever
- Valve Body Sleeve Installation
- Oil Pump Removal Tool
- Possible Blown Fuses On Circuits 420, 422 Or 446 Due To Shorted TCC Wiring
- 1989 B, C, D, F, G, K, M, R, S, T, V, & Y Body Vehicles
- Checking Vehicle For Short To Ground
- Check TCC Wiring Harness For Short To Ground
- Diagnostic Hints
- Diagnosis Information For Possible Inoperative Torque Converter Or Related Condition
- New Low & Reverse Clutch Support & Selective Plate Dimensions
- 1990 B, C, D, F, G, K, L, M, R, S, T, V & Y Body Vehicles
- Clutch Apply Plates-Material Changed To Powdered Metal In Forward & 3-4 Clutches
- 1990 B, C, D, F, G, K, L, M,, S, T, V, & 7 Body Vehicles
- Noise/Vibration With Torque Converter Clutch Applied (Replace Torque Converter K7020)
- Erratic Or No Upshift
- Redesigned Clutch Piston Seal
- Proper Spacer Plate Gaskets Usage
- Binding Or Inoperative In Reverse
- Driveline Clunk During Garage Shift Or Hard Acceleration
- 2-4 Band Changes
- 1989 B, C, D, F, G, K, L, M, S, T, V & Y Body Vehicles
- Torque Specifications