Lower Control Valve Body Assembly: Removal
- Remove the bottom pan and seal, scavenge screens, and the lip seals.
- Remove the nine 10-mm bolts (534) from the oil transfer plate (956) and wire harness assembly (943). See Fig 1 .
- Remove the oil transfer plate (956).
- Disconnect the wire harness extension (943) from the wire harness assembly (12). See Fig 2
.NOTE: Do not reuse retainer (915), it must be replaced. See Fig 3 .
- Use a small screwdriver in order to disconnect the manual valve link retainer (915) from the manual valve link (913).NOTE: Do not pry against the internal mode switch assembly.
- Lift the manual valve and link assembly link (913) out of the inside detent lever (17).
- Remove the two, 10-mm nuts (955) and the fourteen, 10-mm bolts (958) from the lower control valve body assembly (903). See Fig 4 .
- Lift the lower channel plate, control valve body and accumulator assembly (903) and the lower control valve body wire harness extension (943) from the case as a single unit.