Fuse Block: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.




1. Disconnect the battery negative cable.
2. Remove the battery positive cable cover.




3. Remove the battery positive cable bolt.
4. Remove the battery positive cable.




5. Remove the bolts that attach the underhood electrical center to the underhood electrical center support bracket.




6. Loosen the bolts that secure the electrical connectors to the bottom of the underhood electrical center.




7. Disconnect the electrical connectors.
8. Remove the underhood electrical center from the vehicle.

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Cautions and Notices.




1. Connect the electrical connectors.

Tighten
Tighten the electrical connector bolts to 7 N.m (62 lb in).




2. Install the bolts that attach the underhood electrical center to the underhood electrical center support bracket.

Tighten
Tighten the electrical connector bolts to 7 N.m (62 lb in).




3. Attach the battery positive cable with bolt.

Tighten
Tighten the battery positive cable bolt to 10 N.m (88 lb in).




4. Replace the battery positive cable cover.
5. Connect battery negative cable.