Pull-In Windings Test
Connect test equipment. See HOLD-IN WINDINGS TEST. See Figure. Ground terminal "M" of solenoid. Adjust voltage to 10 volts and note ammeter reading. See PULL-IN WINDINGS SPECIFICATIONS table.
NOTE:
Current will decrease as windings heat up.
PULL-IN WINDINGS SPECIFICATIONS
| Starter Motor | (1) Amperage | ||
|---|---|---|---|
| SD200 | 36-49 | ||
| SD210 | 42-51 | ||
| SD250 | 36-49 | ||
| SD260 | 55-80 | ||
| SD300 | 55-80 | ||
|
|||