Component Inspection
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following condition.
ECM
Condition
Voltage
Connector
+
-
Terminal
F19
88
85
Accelerator pedal
Fully released
More than 0.36 V
Fully depressed
Less than 4.75 V
80
Fully released
Less than 4.75 V
Fully depressed
More than 0.36 V
Is the inspection result normal?
YES
INSPECTION END
NO
Replace accelerator pedal assembly. Refer to ACCELERATOR CONTROL SYSTEM : Removal & Installation .