Required Tools

WARNING: This page is about a different car, the 2020 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.

Radar Sensor Aiming Kit 1-20-2851-1 Kit includes the following:

a) Target Board (Fixture)

b) Laser assembly

c) Rear Stand

Use kit 1-20-2851-1 with a self-centering wheel adapter (e.g. 1-20-2722-1-IF, Hunter 20-3339-1 or equivalent).

NOTE: Tools 1-20-2721-1-IF, 1-20-2722-1-IF and J-50808 have been superseded and are no longer available, but may still be used for ICC Sensor alignment.

The following tools are necessary to perform ICC sensor alignment:

Target board

Courtesy of NISSAN NORTH AMERICA, INC.
1. : Position 1, with top tilted 2 deg. toward vehicle (not used).
2. : Position 2, vertical.
3. : Position 3, with top tilted 2 deg. away from vehicle (not used).
Hunter self-centering wheel adapter [shown with laser assembly installed] (Hunter alignment rack head may be substituted.)

Courtesy of NISSAN NORTH AMERICA, INC.
NOTE:
- Directional arrows and are shown to illustrate the direction of the laser assembly beams.
Laser assembly (with bi-directional laser beam) as shown in the illustration

Courtesy of NISSAN NORTH AMERICA, INC.
1. Tightening knob
2. Power ON/OFF button
3. Front laser beam opening
4. Rear laser beam opening
5. Attaching shaft
Rear stand as shown in the illustration

Courtesy of NISSAN NORTH AMERICA, INC.
1. Rear stand
2. Laser signal reception plate