Active Test Mode

TEST ITEM

CONDITION

JUDGEMENT

CHECK ITEM (REMEDY)

ENG COOLANT TEMP

• Engine: Return to the original trouble condition
• Change the engine coolant temperature using CONSULT.

If trouble symptom disappears, see CHECK ITEM.

• Harness and connectors
• Engine coolant temperature sensor
• Fuel injector

FUEL INJECTION

• Engine: Return to the original trouble condition
• Change the amount of fuel injection using CONSULT.

If trouble symptom disappears, see CHECK ITEM.

• Harness and connectors
• Fuel injector
• Air fuel ratio (A/F) sensor 1

PURG VOL CONT/V

• Engine: After warming up, run engine at 1, 500 RPM.
• Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.

Engine speed changes according to the opening percent.

• Harness and connectors
• Solenoid valve

FUEL/T TEMP SEN

Change the fuel tank temperature using CONSULT.

POWER BALANCE

• Engine: After warming up, idle the engine.
• A/C switch OFF
• Selector lever: P or N
• Cut off each injector signal one at a time using CONSULT.

Engine runs rough or dies.

• Harness and connectors
• Compression
• Fuel injector
• Power transistor
• Spark plug
• Ignition coil

EXT V/T ASSIGN ANGLE

• Engine: Return to the original non-standard condition
• Change exhaust valve timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Exhaust valve timing control solenoid valve

VIAS S/V-1

• Ignition switch: ON (Engine stopped)
• Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.

Solenoid valve makes the operating sound

• Harness and connectors
• Solenoid valve

VENT CONTROL/V

• Ignition switch: ON (Engine stopped)
• Turn solenoid valve "ON" and "OFF" with the CONSULT and listen to operating sound.

Solenoid valve makes an operating sound.

• Harness and connectors
• Solenoid valve

FAN DUTY CONTROL*

• Ignition switch: ON
• Change duty ratio using CONSULT.

Cooling fan speed changes.

• Harness and connectors
• Cooling fan motor
• Cooling fan relay
• Cooling fan control module
• IPDM E/R

VIAS S/V-2

• Ignition switch: ON (Engine stopped)
• Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.

Solenoid valve makes the operating sound

• Harness and connectors
• Solenoid valve

FPCM

• Engine: Return to the original trouble condition
• Select "LOW", "MID" and "HI" with CONSULT.

Fuel pump speed changes or stops.

• Harness and connectors
• Fuel pump control module (FPCM)

IGNITION TIMING

• Engine: Return to the original trouble condition
• Timing light: Set
• Retard the ignition timing using CONSULT.

If trouble symptom disappears, see CHECK ITEM.

Perform Idle Air Volume Learning.

ENGINE OIL PRESSURE CONTROL SOLENOID VALVE

• Water temperature: >-10°C
• Engine oil temperature: < 120°C (248°F)
• Engine speed: < 4000 RPM

Engine oil pressure change

• Harness and connectors
• Engine oil pressure control solenoid valve
• Engine oil pressure sensor
• Engine oil pump