Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

START
Do you have CONSULT?

YES

GO TO STEP 2 .

NO

GO TO STEP 3 .
ELECTRIC INTAKE VALVE TIMING (IVT) CONTROL ACTUATOR REFERENCE POSITION LEARNING
With CONSULT
1. Turn ignition switch ON.
2. On CONSULT screen, select All DTC Reading and check that any DTC is not detected.
3. Select "ENGINE" >> "Work support" >> "Electric intake valve timing control learning".
4. Touch "Start" and start the engine within 10 seconds.
5. Let the engine be idle.
6. Check that "COMPLETED" is displayed.
Is the learning completed normally?

YES

END

NO

Check that DTC is not detected and restart the learning.
PERFORM ELECTRIC IVT CONTROL ACTUATOR REFERENCE POSITION LEARNING
Without CONSULT
1. Turn ignition switch OFF.
2. Disconnect electric IVT control actuator harness connector (actuator side).
3. Turn ignition switch ON and wait at least 70 seconds.
4. Turn ignition switch OFF.
5. Reconnect the disconnected harness connector.
6. Start engine and let it idle at least 15 seconds.
7. Turn ignition switch OFF.
8. Check and erase DTC.
END