LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2018 >> Kicks S >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0420 >> DTC P0340: CMP Sensor (Phase) >> Component Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Inspection

  1. CHECK INTAKE CAMSHAFT POSITION SENSOR-I 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect intake camshaft position sensor harness connector.
    4. Remove the sensor. Refer to Exploded View .
    5. Visually check the sensor for chipping.
      G04812293Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace intake camshaft position sensor. Refer to Exploded View .

  2. CHECK INTAKE CAMSHAFT POSITION SENSOR-II 

    Check resistance intake camshaft position sensor terminals as follows.

    Terminals (Polarity)

    Resistance [at 25°C (77°F)]

    1 (+) - 2 (-)

    Except 0 or ∞Ω

    1 (+) - 3 (-)

    2 (+) - 3 (-)

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace intake camshaft position sensor. Refer to Exploded View .

scientia non olet · About LEMON Manuals