LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2017 >> Juke SL, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (Except For NISMO RS Models) (1 Of 4) >> DTC/Circuit Diagnosis >> DTC P0046: WASTEGATE Control Motor >> DTC Logic >> DTC Confirmation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TEST CONDITION:

    Before performing the following procedure, confirm that battery voltage is between more than 11 V at idle.

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON and wait at least 10 seconds.
    2. Start the engine and warm it up to normal operating temperature.
    3. Check 1st trip DTC. (If actuator motor is stuck on the valve closing side, 1st trip DTC is detected during the above procedure. If 1st trip DTC is not detected, actuator motor may be stuck on the valve opening side. In this case, follow the instruction below.)
    4. Drive the vehicle and accelerate from 20km/h (13 MPH) to 80km/h (50 MPH) within 10 seconds.
      CAUTION:

      Always drive at safe speed.

    5. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals