Diagnostic Test
- CHECK BATTERY CURRENT SENSOR POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect battery current sensor harness connector.
- Turn ignition switch ON.
- Check the voltage between battery current sensor harness connector and ground.
+ - Voltage
(Approx.)Battery current sensor Connector Terminal F54 1 Ground 5.0 V
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
GO TO STEP 2 .
- CHECK SENSOR POWER SUPPLY 2 CIRCUIT
Check sensor power supply 2 circuit. Refer to DIAGNOSIS PROCEDURE .
Is the inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit.
NO
Repair or replace error-detected parts.
- CHECK BATTERY CURRENT SENSOR GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between battery current sensor harness connector and ECM harness connector.
+ - Continuity Battery current sensor ECM Connector Terminal Connector Terminal F54 3 F25 62 Existed - Also check harness for short to power.
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair or replace error-detected parts.
- CHECK BATTERY CURRENT SENSOR INPUT SIGNAL CIRCUIT
- Check the continuity between battery current sensor harness connector and ECM harness connector.
+ - Continuity Battery current sensor ECM Connector Terminal Connector Terminal F54 4 F25 63 Existed - Also check harness for short to ground and to power.
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Repair or replace error-detected parts
- Check the continuity between battery current sensor harness connector and ECM harness connector.
- CHECK BATTERY CURRENT SENSOR
Check the battery current sensor. Refer to COMPONENT INSPECTION (BATTERY CURRENT SENSOR) .
Is the inspection result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Replace battery current sensor. Refer to REMOVAL AND INSTALLATION .