Detailed Flow

INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE: The customers are not professionals. Never assume that "maybe the customer means..." or "maybe the customer mentioned this symptom".

: GO TO 2.
SELF-DIAGNOSIS WITH CONSULT
1. Perform "All DTC Reading" with CONSULT.
2. Check if the DTC is detected on the "Self-Diagnostic Results" of following:
  - "DISTANCE SENSOR"
  - "AROUND VIEW MONITOR"
    Is any DTC detected?
    
    YES: GO TO 5.
    
    NO: GO TO 3.
ACTION TEST
Perform the following system action test to check the system operation:
- LDW refer to "LDW: DESCRIPTION ".
- BSW refer to "BSW: DESCRIPTION ".
- MOD refer to "MOD: DESCRIPTION ".
  Check if any other malfunctions occur.
  
  : GO TO 4.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to "SYMPTOM TABLE ".

: GO TO 6.
TROUBLE DIAGNOSIS BY DTC
1. Check the DTC in the "Self-Diagnostic Results".
2. Perform trouble diagnosis for the detected DTC following:
  - "DISTANCE SENSOR": Refer to "DTC INDEX ".
  - "AROUND VIEW MONITOR": Refer to "DTC INDEX ".
    : GO TO 6.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.

: GO TO 7.
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
1. Erases self-diagnosis results.
2. Perform "All DTC Reading" again after repairing or replacing the specific items.
3. Check if any DTC is detected in self-diagnosis results of following:
  - "DISTANCE SENSOR"
  - "AROUND VIEW MONITOR"
    Is any DTC detected?
    
    YES: GO TO 5.
    
    NO: GO TO 8.
REPAIR CHECK (ACTION TEST)
Perform the following system action test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES: GO TO 4.

NO: Inspection End.