Power Supply Position Change Table By Push-Button Ignition Switch Operation

WARNING: This page is about a different car, the 2014 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.

The power supply position changing operation can be performed with the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions,
A/T models
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operating condition
- Vehicle speed

VEHICLE SPEED CHART

Power supply position	Engine start/stop condition			Push-button ignition switch operation frequency
	A/T models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
LOCK → ACC	-	Not depressed	Not depressed	1
LOCK → ACC → ON	-	Not depressed	Not depressed	2
LOCK → ACC → ON → OFF	-	Not depressed	Not depressed	3
LOCK → START ACC → START ON → START	P or N position	Depressed	Depressed	1
Engine is running → OFF	-	-	-	1

VEHICLE SPEED CHART

Power supply position	Engine start/stop condition			Push-button ignition switch operation frequency
	A/T models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
Engine is running → ACC	-	-	-	Emergency stop operation
Engine stall return operation while driving	N position	Not depressed	Depressed	1

Emergency stop operation

Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times or more within 1.5 seconds.