System Description
- EPS control unit performs an arithmetical operation on data, such as steering wheel turning force (sensor signal) from the torque sensor, vehicle speed signal, etc. Then it generates an optimum assist torque signal to the EPS motor according to the driving condition.
- EPS control unit decreases the output signal to EPS motor while extremely using the power steering function (e.g., full steering) consecutively for protecting EPS motor and EPS control unit (Overload protection control). While activating overload protection control, the assist torque gradually decreases, and the steering wheel turning force becomes heavy. The normal assist torque reactivates by no steering.
- In case of an error in the electrical system, the fail-safe function stops output signals to the EPS motor. Then the previous state is changed to the manual steering state.
- Self-diagnosis can be done with CONSULT-III.
- EPS control unit will decrease assistance under the following 2 conditions.
- Extensive steering at low speed will cause the ECU and MOTOR to heat up, once temperature reaches critical point ECU will reduce current to reduce heat up. System will recover as temperature lowers (reduced or no assistance).
- Holding steering on rack-end (full lock) for 1 second will cause the system to engage rack-end protection. This reduces assistance down to 50% in order to prevent heat up. Assistance is immediately returned to 100% when steering released or turned away from rack-end.
- Communicates the signal from each control unit via CAN communication.SIGNAL SPECIFICATION
Control unit Signal status ECM Transmits mainly the following signals to EPS control unit via CAN communication.
Engine status signalABS actuator and electric unit (control unit) Transmits mainly the following signals to EPS control unit via CAN communication.
Vehicle speed signalCombination meter - Transmits mainly the following signals to EPS control unit via CAN communication. Vehicle speed signal
- EPS warning lamp signal is received from the EPS control unit via CAN communication.
TCM (Without ABS) Transmits the following signals via CAN communication to EPS control until.
Engine status signal- Vehicle speed signal