DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2.

1. Start the engine and warm it up to normal operating temperature.
2. Drive the vehicle for at least 5 seconds under the following conditions:
   CAUTION: Always drive vehicle at safe speed.
   VEHICLE DRIVE CONDITIONS
   
   

   Selector lever	Suitable position
   Vehicle speed	40 km/h (25 MPH) or more

3. Check 1st trip DTC.

   Is 1st trip DTC detected? 

   YES: Proceed to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END