LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0181 To P0500 (MR20DE) (Except CALIFORNIA) >> DTC P0222, P0223 TP Sensor >> Diagnosis Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Diagnosis Procedure

  1. CHECK GROUND CONNECTIONS
    1. Turn ignition switch OFF.
    2. Loosen and retighten ground screws on the body.

      Refer to "GROUND INSPECTION ".

      • : Vehicle front
      • Body ground (1)

      OK or NG 

      OK: GO TO 2.

      NG: Repair or replace ground connections.

      Fig 1: Location Of Body Ground
      G07139970Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK THROTTLE POSITION SENSOR 1 POWER SUPPLY CIRCUIT-I
    1. Disconnect electric throttle control actuator (1) harness connector.
    2. Turn ignition switch ON.
      Fig 2: Location Of Electric Throttle Control Actuator
      G07139971Courtesy of NISSAN MOTOR CO., U.S.A.
    3. Check voltage between electric throttle control actuator terminal 2 and ground with CONSULT-III or tester.

      Voltage: Approximately 5 V 

      OK or NG 

      OK: GO TO 3.

      NG: Repair open circuit or short to ground or short to power in harness connectors.

      Fig 3: Checking Voltage Between Electric Throttle Control Actuator Terminal 2 And Ground
      G07139972Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK THROTTLE POSITION SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between ECM terminal 36 and electric throttle control actuator terminal 4.

      Refer to WIRING DIAGRAM .

      Continuity should exist  .

    4. Also check harness for short to ground or short to power.

      OK or NG 

      OK: GO TO 4.

      NG: Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK THROTTLE POSITION SENSOR 1 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Check harness continuity between ECM terminal 33 and electric throttle control actuator terminal 1.

      Refer to WIRING DIAGRAM .

      Continuity should exist  .

    2. Also check harness for short to ground and short to power.

      OK or NG 

      OK: GO TO 5.

      NG: Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK THROTTLE POSITION SENSOR

    Refer to "COMPONENT INSPECTION ".

    OK or NG 

    OK: GO TO  7.

    NG: GO TO 6.

  6. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

    Replace the electric throttle control actuator. Refer to INTAKE MANIFOLD .

    INSPECTION END 

  7. CHECK INTERMITTENT INCIDENT

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    INSPECTION END