LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Rogue Krom, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0643 To P2A00 - For CALIFORNIA >> DTC P1805: Brake Switch >> Component Inspection (Stop Lamp Switch)
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Component Inspection (Stop Lamp Switch)

  1. CHECK STOP LAMP SWITCH-I
    1. Turn ignition switch OFF.
    2. Disconnect stop lamp switch harness connector.
    3. Check the continuity between stop lamp switch terminals under the following conditions.
    CONTINUITY REFERENCE CHART

    Terminals Condition Continuity
    1 and 2 Brake pedal Fully released Not existed
    Slightly depressed Existed

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Go to 2.

  2. CHECK STOP LAMP SWITCH-II
    1. Adjust stop lamp switch installation. Refer to " INSPECTION AND ADJUSTMENT ".
    2. Check the continuity between stop lamp switch terminals under the following conditions.
    CONTINUITY REFERENCE CHART

    Terminals Condition Continuity
    1 and 2 Brake pedal Fully released Not existed
    Slightly depressed Existed

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace stop lamp switch. Refer to " REMOVAL AND INSTALLATION ".

scientia non olet · About LEMON Manuals