July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Inspection

CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-I

Disconnect intake valve timing control solenoid valve harness connector.

Check resistance between intake valve timing control solenoid valve terminals as per the following.

RESISTANCE REFERENCE CHART

Terminals	Resistance
1 and 2	7.0 - 7.5 Ω [at 20°C (68°F)]
1 or 2 and ground	∞ Ω (Continuity should not exist)

Fig 1: Checking Resistance Between Intake Valve Timing Control Solenoid Valve Terminals

G04874916

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Replace malfunctioning intake valve timing control solenoid valve. Refer to "EXPLODED VIEW ".

CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-II
1. Remove intake valve timing control solenoid valve.
2. Provide 12 V DC between intake valve timing control solenoid valve terminals 1 and 2, and then interrupt it. Check that the plunger moves as shown in the figure.
  CAUTION: Never apply 12 V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in intake valve timing control solenoid valve.
  
  NOTE: Always replace O-ring when intake valve timing control solenoid valve is removed.
  
  Fig 2: Checking Intake Valve Timing Control Solenoid Valve
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Is the inspection result normal?
  
  YES >> INSPECTION END
  
  NO >> Replace malfunctioning intake valve timing control solenoid valve. Refer to "EXPLODED VIEW ".