LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2010 >> Cube Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Introduction >> DTC/Circuit Diagnosis >> Trouble Diagnosis - Specification Value >> Component Function Check
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Component Function Check

  1. START

    Make sure that all of the following conditions are satisfied.

    • Vehicle driven distance: More than 5, 000 km (3, 107 miles)
    • Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm2 , 14.25 - 15.12 psi)
    • Atmospheric temperature: 20 - 30°C (68 - 86°F)
    • Engine coolant temperature: 75 - 95°C (167 - 203°F)
    • Transmission: Warmed-up
      • CVT models: After the engine is warmed up to normal operating temperature, drive vehicle until "FLUID TEMP SE" (CVT fluid temperature sensor signal) indicates more than 60°C (140°F).
      • M/T models: After the engine is warmed up to normal operating temperature, drive vehicle for 5 minutes.
    • Electrical load: Not applied
      • Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
    • Engine speed: Idle

    GO TO 2.

  2. PERFORM "SPEC" OF "DATA MONITOR" MODE

    With CONSULT-III 

    NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
    1. Perform "BASIC INSPECTION : SPECIAL REPAIR REQUIREMENT ".
    2. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
    3. Make sure that monitor items are within the SP value.

    Is the inspection result normal? 

    YES: END

    NO: Go to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals