October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Front Power Window LH Circuit Inspection

CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL

Turn ignition switch ON.
Check voltage between main power window and door lock/unlock switch connector and ground.

VOLTAGE SPECIFICATION

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D5	16	Ground	UP	0
	16		DOWN	Battery voltage
	12		UP	Battery voltage
	12		DOWN	0

Fig 1: Checking Voltage Between Main Power Window And Door Lock/Unlock Switch Connector And Ground

G05922833

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ".

CHECK POWER WINDOW MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and front power window motor LH.
3. Check continuity between main power window and door lock/unlock switch connector D5 (A) terminals 6, 7 and front power window motor LH connector D8 (B) terminals 1, 3.
  16 - 3 : Continuity should exist.
  
  12 - 1 : Continuity should exist.
4. Check continuity between main power window and door lock/unlock switch connector (A) terminals 6, 7 and ground.
  
  Fig 2: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch Connector Terminals And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  16 - Ground : Continuity should not exist.
  
  12 - Ground : Continuity should not exist.
OK or NG

OK: Replace front power window motor LH. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.