October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Throttle Position Sensor
- Reconnect all harness connectors disconnected.
- Perform
"THROTTLE VALVE CLOSED POSITION LEARNING
".
- Turn ignition switch ON.
- Set shift lever to D (A/T) or 1st (M/T) position.
- Check voltage between ECM terminals 30 [TP sensor 1 (bank 1) signal], 31 [TP sensor 1 (bank 2) signal], 34 [TP sensor 2 (bank 1) signal]. 35 [TP sensor 2 (bank 2) signal] and ground under the following conditions.
Courtesy of NISSAN MOTOR CO., U.S.A. VOLTAGE SPECIFICATION
| Terminal |
Accelerator pedal |
Voltage |
30 [TP sensor 1 (bank 1)]
31 [TP sensor 1 (bank 2)] |
Fully released |
More than 0.36V |
| Fully depressed |
Less than 4.75V |
34 [TP sensor 2 (bank 1)]
35 [TP sensor 2 (bank 2)] |
Fully released |
Less than 4.75V |
| Fully depressed |
More than 0.36V |
- If NG, replace electric throttle control actuator and go to the next step.
- Perform
"THROTTLE VALVE CLOSED POSITION LEARNING
".
- Perform
"IDLE AIR VOLUME LEARNING
".