LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Power Steering System) >> Steering Column >> Removal and Installation >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spiral cable with the combination switches attached from the steering column assembly. Refer to "REMOVAL ".
  2. Remove the lower instrument panel LH. Refer to "LOWER INSTRUMENT PANEL LH ".
  3. Remove the steering column cover and ignition key finisher. Refer to "INSTRUMENT PANEL ASSEMBLY ".
  4. Remove the lower knee protector. Refer to "INSTRUMENT PANEL ASSEMBLY ".
  5. Remove the lock nut and bolt from the upper joint, then separate the upper joint from the upper shaft.
    CAUTION:
    • Do not reuse the lock nut.
    Fig 1: Identifying Lock Nut And Bolt
    G04902301
  6. Remove the three nuts and bolt from the steering column assembly, then remove the steering column assembly from the steering member.
    Fig 2: Identifying Steering Column Assembly Bolt And Nuts
    G04902302
  7. Remove the hole cover seal and clamp.
  8. Remove the hole cover nuts, then remove the hole cover from the dash panel.
  9. Remove the bolt from the lower joint of the lower joint shaft, then remove the lower joint shaft from the vehicle.
    CAUTION:
    • Do not damage the lower joint.
    Fig 3: Identifying Bolt (Lower Side) Of Lower Joint
    G04902303
scientia non olet · About LEMON Manuals