LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Body, Lock & Security System >> Remote Keyless Entry System >> Key Switch Check
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Key Switch Check

  1. CHECK KEY SWITCH INPUT SIGNAL 

    With CONSULT-III 

    Check key switch "KEY ON SW" in DATA MONITOR mode with CONSULT-III. Refer to "DATA MONITOR ".

    • When key is inserted into ignition key cylinder:

      KEY ON SW : ON 

    • When key is removed from ignition key cylinder:

      KEY ON SW : OFF 

    Without CONSULT-III 

    Check voltage between BCM connector and ground.

    CONNECTOR TERMINAL VOLTAGE SPECIFICATION

    Connector Terminals Condition Voltage (V) (Approx.)
    ( + ) ( - )
    M18 37 Ground Key is inserted. Battery voltage
    Key is removed. 0
    Fig 1: Checking Voltage Between BCM Connector And Ground
    G04902460Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Key switch circuit is OK.

    NG: GO TO 2.

  2. CHECK KEY SWITCH 
    1. Turn ignition switch OFF.
    2. Disconnect key switch connector.
    3. Check key switch.
      CONNECTOR TERMINAL CONTINUITY SPECIFICATION

      Terminals Condition Continuity
      1 - 2 Key is inserted. Yes
      Key is removed. No

    OK or NG 

    OK: Check the following.

    • 10A fuse [No. 19, located in fuse block (J/B)]
    • Harness for open or short between key switch and fuse
    • Harness for open or short between BCM and key switch
      Fig 2: Checking Key Switch
      G04927563Courtesy of NISSAN MOTOR CO., U.S.A.

    NG: Replace key switch.

scientia non olet · About LEMON Manuals