Diagnostic Procedure
- CHECK SYSTEM FOR CAN COMMUNICATION LINE
Perform self-diagnosis. Refer to "SELF-DIAG RESULTS MODE ".
Is the "CAN COMM CIRCUIT [U1000]" displayed?
YES: Perform trouble diagnosis for CAN communication line. Refer to "DTC U1000 CAN COMM CIRCUIT ".
NO: GO TO 2.
- CHECK EPS CONTROL UNIT
Check EPS control unit input/output signal. Refer to "EPS CONTROL UNIT INPUT/OUTPUT SIGNAL REFERENCE VALUES ".
OK or NG
OK: GO TO 3.
NG: Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
- SYMPTOM CHECK
Check again.
OK or NG
OK: INSPECTION END
NG: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".