LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Power Steering System) >> Power Steering Gear And Linkage >> Disassembly
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Steering Gear And Linkage: Disassembly

WARNING: This page is about a different car, the 2005 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prior to disassembling, measure pinion rotating torque using Tools.
    • Tool numbers: KV48101100 (J26364) 
      • ST3127S000 (25765-A) 
    • Within +/-100° from the neutral position 
    • Average rotating torque: 0.6 - 2.0 N.m (7 - 20 kg-cm, 6 - 17 in-lb) 
    • Maximum torque deviation: 0.5 N.m (7 kg-cm, 5.8 in-lb) 
    • Except for above measuring range 
    • Maximum rotating torque: 1.9 N.m (19 kg-cm, 17 in-lb) 
    • Maximum torque deviation: 0.65 N.m (7 kg-cm, 6 in-lb) 
    Fig 1: Measuring Pinion Rotating Torque
    G02451754Courtesy of NISSAN MOTOR CO., U.S.A.
    • If pinion rotating torque is not within the specifications, replace steering gear assembly. 
    • Before measuring, disconnect gear housing tube and drain fluid. 
    • Use soft jaws when holding steering gear housing. Handle gear housing carefully, as it is made of aluminum. Do not grip cylinder in a vise. 
  2. Remove tie-rod outer sockets and dust boots.
  3. Remove tie-rod inner sockets.
scientia non olet · About LEMON Manuals