LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2006 >> Altima S, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component Testing (Qr25DE) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONTINUITY CONDITION CHART

    Condition Continuity
    Brake pedal: Fully released. Should not exist.
    Brake pedal: Slightly depressed. Should exist.
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04166681Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, adjust stop lamp switch installation, Refer to , "BRAKE PEDAL ", and perform step  3 again.

scientia non olet · About LEMON Manuals