Front Door Lock Assembly LH (Actuator) Check

1. Turn ignition switch OFF.
2. Disconnect BCM and front door lock assembly LH (actuator).
3. Check continuity between BCM connector M20 (A) terminals 59, 65 and front door lock assembly LH (actuator) connector D9 (B) terminals 1, 2.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Connector	Terminal	Connector	Terminal	Continuity
   A: M20	59	B: D9	2	Yes
   	65		1	Yes

4. Check continuity between BCM connector M20 (A) terminals 59, 65 and body ground.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Connector	Terminals		Continuity
   A: M20	59	Ground	No
   	65		No

OK or NG 

OK: GO TO 2.

NG: Repair or replace harness.

Fig 1: Checking Continuity Between BCM Connector M20 Terminals 59, 65 And Body Ground

1. Reconnect BCM.
2. Check voltage between BCM connector M20 terminals 59, 65 and ground.
   BCM CONNECTOR TERMINAL VOLTAGE SPECIFICATION
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M20	59	Ground	Main power window and door lock/unlock switch is turned to UNLOCK	0 → Battery voltage
   	65		Main power window and door lock/unlock switch is turned to LOCK	0 → Battery voltage

   Fig 2: Checking Voltage Between BCM Connector M20 Terminals 59, 65 And Ground

   

OK or NG 

OK: Replace front door lock assembly LH (actuator). Refer to "REMOVAL AND INSTALLATION ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".