LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2005 >> Quest Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Engine Control System) >> DTC P1572: ASCD Brake Switch >> DTC confirmation Procedure >> With Consult-II
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

With Consult-II

WARNING: This page is about a different car, the 2005 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (VDC switch OFF).
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Press MAIN switch and make sure that CRUISE indicator lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SPECIFICATION

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position

    If DTC is detected, go to DIAGNOSTIC PROCEDURE .

    If DTC is not detected, go to the following step.

    Fig 1: CONSULT-II Display - "DATA MONITOR" Mode
    G02444107Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SPECIFICATION

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position
    Driving location Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned condition.
  6. If DTC is detected, go to DIAGNOSTIC PROCEDURE .
scientia non olet · About LEMON Manuals