With GST

WARNING: This page is about a different variant/trim than selected.

Check voltage between ECM terminal 102 (PNP switch signal) and ground under the following conditions.

CONDITION AND VOLTAGE REFERENCE

Condition (Gear position)	Voltage V (Known good data)
P or N position (A/T) Neutral position (M/T)	Approx.
Except the above position	A/T: Battery voltage M/T: Approximately 5V

If NG, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Checking Voltage Between ECM Terminal 102 (PNP Switch Signal) And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.