LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2005 >> 350Z 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: M/T & A/T Models Stop Lamp Switch Connector Terminals 1 & 2 Continuity Test
    G02402236Courtesy of NISSAN MOTOR CO., U.S.A.
    CONTINUITY SPECIFICATION

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

scientia non olet · About LEMON Manuals