Check Sliding Switch Circuit

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUNCTION

With CONSULT-II

With "SLIDE SW-FR, SLIDE SW-RR" on the DATA MONITOR, operate the sliding switch to check ON/OFF operation.

DATA MONITOR ITEM REFERENCE TABLE

Monitor item [OPERATION or UNIT]		Contents
SLIDE SW - FR	"ON/OFF"	ON/OFF status judged from the sliding switch (FR) signal is displayed.
SLIDE SW - RR	"ON/OFF"	ON/OFF status judged from the sliding switch (RR) signal is displayed.

Fig 1: CONSULT-II Display Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Turn ignition switch OFF.

Sliding switch operate, check voltage between driver seat control unit connector and ground.

VOLTAGE CHECK TABLE

Connector	Terminals (Wire color)		Sliding switch condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Sliding switch condition	Voltage (V) (Approx.)
B352	26 (Y)	Ground	FORWARD	0
	26 (Y)		Other than above	Battery voltage
	11 (BR)		BACKWARD	0
	11 (BR)		Other than above	Battery voltage

OK or NG

OK: Sliding switch circuit is OK.

NG: GO TO 2.

Fig 2: Checking Voltage Between Driver Seat Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK HARNESS CONTINUITY
1. Disconnect driver seat control unit connector and power seat switch connector.
2. Check continuity between driver seat control unit connector B352 terminals 11, 26 and power seat switch connector B355 terminals 11, 26.
  11 (BR) - 11 (BR): Continuity should exist .
  
  26 (Y) - 26 (Y): Continuity should exist .
3. Check continuity between driver seat control unit connector B352 terminals 11, 26 and ground.
  11 (BR) - Ground: Continuity should not exist .
  
  26 (Y) - Ground: Continuity should not exist .
  
  Fig 3: Checking Continuity Between Driver Seat Control Unit And Power Seat Switch Connector Terminals
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: GO TO 3.

NG: Repair or replace harness between driver seat control unit and power seat switch.

CHECK SLIDING SWITCH

Check continuity between power seat switch as follows.

CONTINUITY CHECK TABLE

Terminal		Sliding switch condition	Continuity
26	32D	FORWARD	Yes
26		Other than above	No
11		BACKWARD	Yes
11		Other than above	No

OK or NG

OK: Check the condition of the harness and connector.

NG: Replace power seat switch.

Fig 4: Checking Continuity Between Power Seat Switch Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.