With Consult-II

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

TESTING CONDITION:

Steps 4 and 5 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

Start engine (TCS switch or VDC switch OFF).
Select "DATA MONITOR" mode with CONSULT-II.

Fig 1: CONSULT-II Data Monitor Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Press MAIN switch and make sure that CRUISE indictor lights up.

Drive the vehicle for at least 5 consecutive seconds under the following condition.

VEHICLE SPEED REFERENCE TABLE

VHCL SPEED SE	More than 30 km/h (19 MPH)
Selector lever	Suitable position

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

If 1st trip DTC is not detected, go to the following step.

Drive the vehicle for at least 5 consecutive seconds under the following condition.

VEHICLE SPEED REFERENCE TABLE

VHCL SPEED SE	More than 30 km/h (19 MPH)
Selector lever	Suitable position
Driving location	Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed.

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".