Procedure For DTC P0103

With CONSULT-II 

1. Turn ignition switch ON.
2. If 1st trip DTC is detected,

   Select "DATA MONITOR" mode with CONSULT-II.

3. Wait at least 6 seconds.
4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

   If 1st trip DTC is not detected, go to next step.

5. Start engine and let it idle for at least 6 seconds.
6. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE ".
   Fig 1: Reading "ENG SPEED" In "Data Monitor" Mode

   Courtesy of NISSAN MOTOR CO., U.S.A.

With GST 

Follow the procedure "With CONSULT-II".