How To Use Check Sheet Table

WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Instruction Diagram For Using Check Sheet Table

Unit names displayed on CONSULT-II.
"No indication": Put a check mark to it if the unit name described in step 1 is not displayed on "SELECT SYSTEM" screen of CONSULT-II. (Unit communicating with CONSULT-II via CAN communication line) "-": Column not used (Unit communicating with CONSULT-II excluding CAN communication line)
"NG": Display "NG" when malfunction is detected in the initial diagnosis of the diagnosed unit. Replace the unit if "NG" is displayed.
"-": Column not used (Initial diagnosis is not performed.)
"UNKWN": Display "UNKWN" when the diagnosed unit does not transmit the data normally. Put a check mark to it if "UNKWN" is displayed on CONSULT-II.
"UNKWN": Display "UNKWN" when the diagnosed unit does not receive the data normally. Put a check mark to it if "UNKWN" is displayed on CONSULT-II.
"-": Column not used (It is not necessary for CAN communication trouble diagnosis.)

NOTE: CAN communication diagnosis checks if CAN communication works normally. (Contents of data are not diagnosed.)
- When the initial conditions are reproduced, refer to "EXAMPLE OF FILLING IN CHECK SHEET WHEN INITIAL CONDITIONS ARE REPRODUCED ".
- When the initial conditions are not reproduced, refer to "EXAMPLE OF FILLING IN CHECK SHEET WHEN INITIAL CONDITIONS ARE NOT REPRODUCED ".