October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
DTC Confirmation Test (Using Generic Scan Tool)
- Turn ignition on. Select MODE 1 with scan tool. Ensure engine coolant temperature is 14-95°F (-10-60°C).
- Measure voltage between ground and EGR temperature sensor circuit at ECM terminal No. 63 by backprobing. See Figure
or Figure
. See Figure
. Ensure voltage is less than 4.8 volts.
- Start engine and let it idle for at least 60 seconds.
- Stop engine. Repeat steps 1
- 3
.
- Select MODE 3 with scan tool. If DTC is detected, go to DIAGNOSTIC PROCEDURE
. If DTC is not detected, system is okay at this time.