Color of RGB Image Is Not Proper (Bluish)
WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK RGB HARNESS
- Turn ignition switch OFF.
- Disconnect NAVI control unit connector and display unit connector.
- Check continuity between NAVI control unit harness connector (A) M58 and display unit harness connector (B) M35.
- Check continuity between NAVI control unit harness connector (A) M58 and ground.
- When the screen looks bluish
CONNECTOR TERMINAL CONTINUITY REFERENCETerminals Continuity NAVI control unit Display Connector Terminal Connector Terminal M58 44 M35 1 Yes 47 4 CONNECTOR TERMINAL GROUND CONTINUITY REFERENCETerminals Continuity NAVI control unit Ground Connector Terminal M58 44 No 47 Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK : GO TO 2.
- NG : Repair harness or connector.
- CHECK RGB SIGNAL
- Connect NAVI control unit connector and display unit connector.
- Turn ignition switch ON.
- Display "Color bar" by "CONFIRMATION/ADJUSTMENT" mode.
- Check the signal between NAVI control unit harness connector M58 terminals 44 and 47 with CONSULT-II or oscilloscope.
- When the screen looks bluish
CONNECTOR TERMINAL VOLTAGE REFERENCETerminals Voltage (v) NAVI control unit (+) NAVI control unit (-) Connector Terminal Connector Terminal M58 44 M58 47 Refer to "TERMINALS AND REFERENCE VALUE FOR NAVI CONTROL UNIT ". Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK : Replace display unit.
- NG : Replace NAVI control unit.