LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2025 >> Eclipse Cross LE >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle >> Driveshaft Assembly >> Outboard Joint Boot Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Outboard Joint Boot Replacement

Required Special Tool: 

  1. Remove the boot band (large) and (small).
    NOTE: Boot band cannot be reused.
  2. Remove the boot.
  3. Wipe off the grease on the outboard joint.
  4. Apply a tape to the shaft spline area, and then incorporate the new boot band and new boot.
    G12120192Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the boot, aligning with the center groove on the boot small diameter.
    G05376121Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Roughly position the new boot band (small) at the center so that there are clearance at both ends (A and B).
    G12120195Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  7. Crimp the new boot band (small) in several stages by using the special tool boot band crimping tool (MB991561) so that the crimping value (C) is within the standard value.

    Standard value (C): 1.2 - 4.5 mm (0.05 - 0.18 inch) 

    CAUTION: Do not turn the adjusting bolt of the special tool boot band crimping tool (MB991561) more than once. Otherwise, the special tool may be damaged.
    G12120196Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    G05904335Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  8. If the crimping value (C) is not within the standard value, tighten the adjusting bolt of the special tool boot band crimping tool (MB991561) to crimp it again.
    NOTE: The adjusting bolt changes (W) approximately 0.7 mm (0.03 inch) for each rotation.
  9. Check that the boot band is not sticking out past the place where it has been installed. If the boot band is sticking out, remove it and then repeat steps  6 to  8, using a new boot band.
    CAUTION: The special grease is used for the joint: Do not mix old and new grease, or grease in different types.
    G12681176Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  10. Fill the boot with the specified amount of specified grease.

    Specified grease: Repair kit grease 

    Amount used:  Refer to SERVICE SPECIFICATIONS  .

  11. Align the center groove on the resin boot large diameter with the shaft groove.
    G05394362Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  12. Roughly position the new boot band (large) at the center so that there are clearance at both ends (D and E).
  13. As shown in step  7, use the special tool boot band crimping tool (MB991561) to crimp the boot band (large).
  14. Check that the boot band is not sticking out past the place where it has been installed. If the boot band is sticking out, remove it and then repeat steps  12 and  13, using a new boot band.
    G13323764Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals