Airbag Control System (1 Of 2): Precaution: Precautions: Service

• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Information.
• Before servicing the SRS, ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.

For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, never work on any SRS connectors or wires until at least 3 minutes have passed.

• Diagnosis sensor unit must always be installed with their arrow marks "e=" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.
• The spiral cable must be aligned with the neutral position since its rotations are limited. Never turn steering wheel and column after removal of steering gear.
• Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side facing upward and seat mounted front side air bag module standing with the stud bolt side facing down.
• Conduct self-diagnosis to check entire SRS for proper function after replacing any components.
• After air bag inflates, the front instrument panel assembly should be replaced if damaged.
• Always replace instrument panel pad following front passenger air bag deployment.
• Never solder the harness when making repairs. Check that harness is not pinched and that there is no contact with other components.
• Never allow harness to come in contact with oil, grease, waste oil, or water.
• Never insert foreign materials, such as a screwdriver, into the harness connector. (This is to prevent accidental activation caused by static electricity.)
• Always use M.U.T.-III SE or SRS air bag warning light to perform the circuit diagnosis. (Never use an electric tester such as a circuit tester.)