October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Cruise Control Switch Check
- Remove the cruise control switch (Refer to TRANSMISSION RANGE SWITCH ("N" POSITION) CHECK ).
- Measure the resistance between terminal No. 3 and terminal No. 4 when each of the cruise control ON/OFF, CANCEL, SET - and RES + switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
| Terminal connector of tester |
Switch position |
Specified condition |
| 3 - 4 |
All switches are released. |
Open circuit |
| Cruise control ON/OFF switch is pressed |
176 - 180 Ω |
| CANCEL switch is pressed |
460 - 470 Ω |
| SET - switch is pressed |
1, 030 - 1, 051 Ω |
| RES + switch is pressed |
2, 725 - 2, 837 Ω |
 Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
|
- Check that illumination of the cruise control switch turns on when the battery positive terminal is connected to cruise control switch connector terminal No. 5, and the battery negative terminal is connected to cruise control switch connector terminal No. 6.