Cruise Control Switch Check
- Remove the cruise control switch (Refer to CRUISE CONTROL SWITCH .)
- Measure the resistance between terminal number 2 and terminal number 3 when each of the "CRUISE ON/OFF", "CANCEL", "SET-" and "RES+" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Terminal connector of tester Switch position Specified condition 2 - 3 All switches are released. Open circuit "CRUISE ON/OFF" switch is pressed Continuity (less than 2 ohms) "CANCEL" switch is pressed 203 - 207 Ω "SET-" switch is pressed 611 - 623 Ω "RES+" switch is pressed 1839 - 1875 Ω - Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal number 1 is grounded.