Abs Light Flashing After ASC Ecu Replacement (MTT-1008-07)
Publication date: 2007-01-01Reference number: MTT-1008-07
ABS LIGHT FLASHING AFTER ASC ECU REPLACEMENT
TECHNICAL INFORMATION TIP - MANUFACTURER
Reference Number(s): MTT-1008-07, Date of Issue:
January, 2007
| MITSUBISHI: | 2007 & later Outlander |
SERVICE INFORMATION
ABS LIGHT FLASHING AFTER ASC ECU REPLACEMENT - 2007 & later Outlander . After replacing an ASC hydraulic unit, the ABS light will flash, with no DTCs stored. After battery disconnection or ASC hydraulic unit replacement, it is necessary to recalibrate the Steering Angle sensor and the G and Yaw rate sensors. From the MUT-III Main Menu,
- Select System Select and enter the vehicle information.
- Select ABS / ASC / ASTC
- Select "Special Function."
- Select 'All Sensor Calibration' to complete the available calibrations.
Don't forget to erase 'All DTCs' when finished