LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2012 >> Lancer SE >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 16 >> Test Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Accelerate until the vehicle speed is more than 50 km/h (31 mph).
  3. Stop at safe place and let the engine idle for 20 seconds. (During the monitor)
  4. Repeat Steps 2 and 3 for 10 times.
  5. Stop the vehicle at the safe place and turn the ignition switch to "LOCK" (OFF) position.
  6. Start the engine and do Steps 1 to 5 again.
  7. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals