Combination Meter Assembly
- General Description
- Combination Meters Diagnosis
- Diagnostic Trouble Code Procedures
- DTC B1200: Defective odometer
- DTC B1201: Defective fuel gauge
- DTC U1073: Bus off
- DTC U1100: ECM
or PCM time-out (related to engine) - DTC U1101: PCM time-out (related to A/T)
- DTC U1102: TCL/ASC-ECU time-out
- DTC U1109: ETACS-ECU time-out
- DTC U1112: SRS-ECU time-out
- DTC U1114: TPMS-ECU time-out
- DTC U1120: Failure information on ECM
or PCM (related to engine) - DTC U1206: Flag invalid
- DTC U1434: Failure information on TPMS-ECU
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with scan tool is not possible
- INSPECTION PROCEDURE 2: Power supply circuit.; INSPECTION PROCEDURE 3: Odometer and trip meter are not displayed.; INSPECTION PROCEDURE 4: No needle meters work.; INSPECTION PROCEDURE 5: When the ignition switch is turned to the ON position, the indicator and warning lights do not illuminate
- INSPECTION PROCEDURE 6: Speedometer does not work (other meters work); INSPECTION PROCEDURE 7: The fuel gauge needle moves excessively
- INSPECTION PROCEDURE 8: Tachometer does not work (other meters work)
- INSPECTION PROCEDURE 9: Fuel gauge does not work (other meters work)
- INSPECTION PROCEDURE 10: Engine coolant temperature gauge does not work (other meters work)
- INSPECTION PROCEDURE 11: The Fuel Warning Light does not Illuminate or go out
- Data List Reference Table
- Actuator Test Reference Table
- Combination Meter Terminal Check
- Special Tools
- On-Vehicle Service
- Combination Meter Assembly