Chassis Electrical
- Battery
- Ignition Switch*
- Immobilizer System
- General Description
- Encrypted Code Registration Criteria Table
- Immobilizer System Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- Data List Reference Table
- Check At ETACS-Ecu (Immobilizer-Ecu) Terminal
- Special Tools
- On-Vehicle Service
- Key Ring Antenna
- ETACS-Ecu
- Combination Meter Assembly
- General Description
- Combination Meters Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Defective Odometer
- DTC B1201: Defective Fuel Gauge
- DTC U1073: Bus Off
- DTC U1100: ECM < M/T> Or Pcm < A/T> Time-Out (Related To Engine)
- DTC U1101: Pcm Time-Out (Related To A/T) < A/T>
- DTC U1102: Abs-Ecu Time-Out
- DTC U1109: ETACS-Ecu Time-Out
- DTC U1112: SRS-Ecu Time-Out
- DTC U1114: TPMS-Ecu Time-Out
- DTC U1120: Failure Information On ECM < M/T> Or Pcm < A/T> (Related To Engine)
- DTC U1206: Flag Invalid
- DTC U1434: Failure Information On TPMS-Ecu
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Communication With Scan Tool Is Not Possible
- Inspection Procedure 2: Power Supply Circuit; Inspection Procedure 3: Odometer And Trip Meter Are Not Displayed; Inspection Procedure 4: All The Needle Meters Do Not Work; Inspection Procedure 5: When The Ignition Switch Is Turned To The On Position, The Indicator And Warning Lights Do Not Illuminate
- Inspection Procedure 6: Speedometer Does Not Work (Other Meters Work); Inspection Procedure 7: The Fuel Gauge Needle Moves Excessively
- Inspection Procedure 8: Tachometer Does Not Work (Other Meters Work)
- Inspection Procedure 9: Fuel Gauge Does Not Work (Other Meters Work)
- Inspection Procedure 10: Engine Coolant Temperature Gauge Does Not Work (Other Meters Work)
- Inspection Procedure 11: The Fuel Warning Light Does Not Illuminate Or Go Out
- Data List Reference Table
- Actuator Test Reference Table
- Combination Meter Terminal Check
- Special Tools
- On-Vehicle Service
- Combination Meter Assembly
- Headlight, Front Side Marker Light And Position Light Assembly
- Fog Light
- Rear Combination Light
- Dome Light
- License Plate Light
- High-Mounted Stop Light
- Hazard Warning Light Switch
- Column Switch
- Horn
- Accessory Socket
- Radio With Cd Player
- General Description
- Radio With Cd Player, Speaker And Antenna Diagnosis
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: When Power Switch Is Turned "On," No Power Is Available
- Inspection Procedure 2: Remote Controlled Radio Switch: When Remote Controlled Radio Power Switch Is Turned "On," No Power Is Available, But Radio And Cd Player With Cd Changer Power Switch Is Available < Vehicles With Audio Amplifier>
- Inspection Procedure 3: Remote Controlled Radio Switch: The System Does Not Recognize The Remote Controlled Radio Switch (RH) Only < Vehicles With Audio Amplifier>
- Inspection Procedure 4: Remote Controlled Radio Switch: The System Does Not Recognize The Remote Controlled Radio Switch (LH) Only < Vehicles With Audio Amplifier>
- Inspection Procedure 5: No Sound < Vehicles With Audio Amplifier>
- Inspection Procedure 6: No Sound From One Speaker < Vehicles Without Audio Amplifier>
- Inspection Procedure 7: No Sound From Door Speaker Or Woofer < Vehicles With Audio Amplifier>
- Inspection Procedure 8: No Sound From Tweeter Or Quarter Speaker < Vehicles With Audio Amplifier>
- Inspection Procedure 9: Noise: Noise Is Present While Moving (Am)
- Inspection Procedure 10: Noise: Noise Is Present While Moving (Fm)
- Inspection Procedure 11: Noise: Sound Mixed With Noise, Only At Night (Am)
- Inspection Procedure 12: Noise: Noise Is Overpowering Both Am And Fm
- Inspection Procedure 13: Noise: Excessive Noise On Am And Fm
- Inspection Procedure 14: Noise: Noise Is Detected With Engine Running
- Inspection Procedure 15: Noise: Noise Appears During Vibration Or Shocks
- Inspection Procedure 16: Noise: Noise Is Present While Moving (Fm)
- Inspection Procedure 17: Noise: Constant Noise
- Inspection Procedure 18: Radio: No Reception (Am)
- Inspection Procedure 19: Radio: Poor Reception
- Inspection Procedure 20: Radio: Distortion On Am And/Or Fm
- Inspection Procedure 21: Radio: Distortion On Fm Only
- Inspection Procedure 22: Radio: Auto Select Function Inoperative, Too Few Automatic Stations Are Selected
- Inspection Procedure 23: Radio: Preset Stations Are Erased
- Inspection Procedure 24: Cd Player, Cd Auto Changer: Cd Cannot Be Inserted
- Inspection Procedure 25: Cd Player, Cd Auto Changer: No Sound (Cd Only)
- Inspection Procedure 26: Cd Player, Cd Auto Changer: Cd Sound Skips
- Inspection Procedure 27: Cd Player, Cd Auto Changer: Sound Quality Is Poor
- Inspection Procedure 28: Cd Player, Cd Auto Changer: Cd Cannot Be Ejected
- Special Tool
- Radio With Cd Player
- Steering Wheel Audio Remote Control Switch < Vehicles With Audio Amplifier>
- Speaker
- Amplifier
- Antenna
- Satellite Radio Tuner
- General Description
- Diagnosis
- Satellite Radio System Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- Defogger
- Multi-Center Display
- General Description
- Diagnosis
- Symptom Procedures
- Inspection Procedure 1: The Multi-Center Display Does Not Show Any Information
- Inspection Procedure 2: "-" (Ambient Air Temperature Sensor Error) Is Displayed On The Ambient Air Temperature Display < Vehicles With Type 1>
- Inspection Procedure 3: The Ambient Air Temperature Display Does Not Change Normally. < Vehicles With Type 1>
- Inspection Procedure 4: On The Audio Screen, "E" Cannot Proceed To Next Screen
- Inspection Procedure 5: The Compass Can Not Be Calibrated Manually, Or Goes Out Of Calibration Easily < Vehicles With Type 1>
- Check At Multi-Center Display Unit Terminal
- Special Tools
- On-Vehicle Service < Vehicles With Type 1>
- Multi-Center Display
- Ambient Air Temperature Sensor
- Theft Alarm
- Specifications