Auto-Cruise Control Switch Check
- Remove the auto-cruise control switch (Refer to AUTO-CRUISE CONTROL ).
- Measure the resistance between terminal 2 and terminal 3 when each of the "ON/OFF" (MAIN), "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
RESISTANCE SPECIFICATION
| Switch position | Specified condition |
|---|---|
| All switches are OFF. | Open circuit |
| "ON/OFF" (MAIN) switch is "ON". | Continuity (less than 2 ohms) |
| "CANCEL" switch is ON. | 202.5 - 208 Ω |
| "COAST/SET" switch is ON. | 610.5 - 624.5 Ω |
| "ACC/RES" switch is ON. | 1838 - 1877 Ω |